macnil GT ALARM GT1006CB, Installation Manual

Page: 33 / 77

3.2 - GT944 SELF-POWERED SIREN CONNECTIONS
1 - Check that the switch No. 6 is in the OFF position and No. 7 is in the ON position (GT944 SIREN
ENCODED OUTPUT).
2 - Connect the BROWN wire (Negative main power supply) to the negative battery pole.
3 - Connect the RED (Positive main power supply) wire to the positive battery pole via a 5 A fuse.
4 - Connect the BLUE siren wire to the YELLOW/BLACK wire of the alarm control panel.
5 - Connect the GREEN wire to the hood button of the vehicle or to an additional one. Do not connect
this wire if the BONNET protection is available on the CAN BUS line of the vehicle (see vehicle data
sheet). Factory set for stable negative signals. If connected to the original vehicle buttons with
negative impulsive signals (polling) carry out the following procedure:
A - Close the hood and then place the control unit in Quick Test mode.
B - Wait 10 seconds and exit Quick Test mode.
3.3 – SELF-POWERED SIREN CONNECTIONS "VIA RADIO" GT945
1 - Connect the BROWN wire (Negative main power supply) to the negative battery pole.
2 - Connect the RED (Positive main power supply) wire to the positive battery pole via a 5 A fuse.
3 - Connect the GREEN wire to the hood button of the vehicle or to an additional one. Do not connect
this wire if BONNET protection is available on the CAN BUS line of the vehicle (see vehicle data sheet).
Factory set for stable negative signals. If connected to the original vehicle buttons with negative
impulsive signals (polling) carry out the following procedure:
A - Close the hood and then place the control unit in Quick Test mode.
B - Wait 10 seconds and exit Quick Test mode.
6
En