MacDon M205, Installation Instructions Manual

Page: 26 / 30

INSTALLATION INSTRUCTIONS
19. Install bolt and nut removed at (B), just securing nut to
engage threads.
20. Reinstall the lower six bolts (A) that hold the wheel
drive to the windrower leg. Use Loctite
®
243 on the
threads. Loosen tension on chain (D) or vary tension
as necessary to align holes for bolt installation.
NOTE:
Do not close up gap until you have three or more
bolts positively engaged or you will have difficulty
lining up all the bolts. When you have three or
more started, the remaining bolts should thread
in more easily and you can push the drive wheel
flush to windrower leg.
21. Torque bolts (A) to 339 N·m (250 ft·lbf).
22. Re-engage drive wheel. Refer to Step 5., page 17 .
23. Tighten bolt and lock nut at (B).
24. Replace plugs (C) in access holes in windrower legs.
25. Remove chain (D) supporting the wheel drive.
Figure 3.28: Wheel Drive
3.2.3 Reinstalling Drive Wheels
To reinstall the drive wheels, follow these steps:
IMPORTANT:
For model year 2014 and prior windrowers:
Before
installing wheel hardware, inspect nuts and washers.
Verify that they are L9 by checking for markings (A). If
the current hardware is
NOT L9, order kit MD #166590
consisting of new hardware and decals.
Figure 3.29: L9 Hardware (2014 and Prior)
147611
20
Revision B