MacDon M205, Installation Instructions Manual

Page: 23 / 30

INSTALLATION INSTRUCTIONS
3. To disengage drive wheel and allow wheel to rotate:
a. Remove the two hex bolts (A) at the center of the
drive wheel.
b. Remove cap (B), and flip over so that the dished
side faces in.
c. Replace bolts (A). The cap will press on a pin that
disengages the gearbox.
NOTE:
Disengaging the drive wheel will make it possible
to remove the bolts in the next step.
Figure 3.19: Drive Wheel Motor with Center Cap
Disengaged
4. Remove the lower six bolts (A) that hold the wheel drive
to the windrower leg. Do NOT remove the two nuts (B)
located at the top of the wheel drive.
Figure 3.20: Wheel Drive
5. Remove hex bolts (A) at the center of the drive wheel.
Remove cap (B), and flip over so that the dished
side faces out.
Replace bolts. The drive wheel is
re-engaged.
Figure 3.21: Drive Wheel Motor with Center Cap
Disengaged
147611
17
Revision B