![background image](http://html1.mh-extra.com/html/macdon/m205/m205_installation-instructions-manual_3218514025.webp)
13. To access the remaining bolts on the servo:
a.
Pull out the wheel drive assembly approx. 38 mm
(1-1/2 in.).
b.
Rotate the wheel motor with wrench on lock
nut (A) to align servo bolts on both sides. Wedge
a 2 x 4 (B) in top or bottom as necessary.
c.
Through the access holes (C), one at a time,
replace the remaining servo bolts with the hex
socket head screws (MD #136652) provided in
the kit.
14. Repeat Steps
to
to install the
remaining four screws.
Figure 3.25: Wheel Drive Assembly Pulled Out
of Windrower Leg
15. Ease the wheel drive assembly back into the windrower
leg, but don’t push it all the way in.
16. Adjust brake line so that it is once again vertical, and
tighten fitting (A).
17. Push wheel in until you can still see the bolt heads
at (A), leaving a gap of about 6 mm (1/4 in.).
NOTE:
On the left-hand wheel motor there is a speed
sensor. Be careful not to damage it when reinstalling
the wheel drive.
Figure 3.26: Wheel Drive Motor Assembly with
Brake Line Fitting Visible
18. To disengage drive wheel and allow wheel to rotate:
a.
Remove the two hex bolts (A) at the center of the
drive wheel.
b.
Remove cap (B), and flip over so that the dished
side faces in.
c.
Replace bolts (A). The cap will press on a pin that
disengages the gearbox.
Figure 3.27: Drive Wheel Motor with Center Cap
Disengaged
147611
19
Revision B
Summary of Contents for M205
