![background image](http://html1.mh-extra.com/html/macdon/m205/m205_installation-instructions-manual_3218514016.webp)
1.
Park the windrower on level ground, and lower the
header and reel so that the lift cylinders are fully
retracted.
2.
Stop the engine and remove the key.
3.
Open the hood.
For instructions, refer to the windrower operator’s
manual or technical manual.
4.
Place a clean container (at least 75 liters [20 US
gallons]) under drain at the bottom of the hydraulic
reservoir to collect the oil.
5.
Remove drain plug (A) and allow oil to drain.
6.
Change the lift filter. Refer to
.
7.
Inspect particles and clean off any metal debris that
may have accumulated on magnetic plug. Wipe plug
with a clean cloth. Check O-ring condition. Look for
cracking, breakage, or deformation that may impede
sealing ability and replace as required.
8.
Install drain plug (A), torque to 80 N·m (59 ft·lbf).
Figure 3.2: Hydraulic Oil Drain Plug
Removing Lift Filter
Change the lift filter at the same time that the hydraulic oil is changed (1500 hours or every two years).
1.
Stop engine and remove key.
2.
Open the hood.
3.
Locate the lift filter (A) below the hydraulic oil reservoir.
4.
Place a container underneath the filter to catch any oil
that may leak.
NOTE:
If replacing the filter between oil changes, apply
a vacuum to the supply tank to prevent the oil
from running out of the filter head when the filter
is removed.
5.
Clean
around
head
of
the
filter
to
prevent
contamination.
6.
Unscrew the filter (A) with a filter wrench.
Figure 3.3: Hydraulic System
147611
10
Revision B
Summary of Contents for M205
