UNLOADING AND ASSEMBLY
Form # 169007
Model Year - 2009
14
CAUTION
Check to be sure all bystanders have cleared
the area.
c. Start the engine and fully retract header lift
cylinders.
d. Slowly drive tractor forward so that boots (B)
enter header legs (E). Continue to drive slowly
forward until linkages contact support plates in
the lower header legs, and header nudges
forward.
e. Check that linkages are properly engaged in
header legs, contacting support plates.
f. Position center link cylinder (F) with tractor
hydraulics so that it can connect to header.
g. Push down on rod end of link cylinder until hook
engages pin on header and is locked.
NOTE
If optional auto-connect system is
installed, activate link lift cylinder from in
the cab to lower center link onto header.
h. Raise the header fully with the tractor hydraulics.
Stop engine and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
i. Engage lift cylinder stops on both lift cylinders.
j. Install pin (D) through header leg, (engaging U-
bracket in lift linkage) on both sides.
k. Raise header stand (G) to storage position by
pulling pin (H) and lifting stand into uppermost
position. Release pin (H).
l. Remove pin (J) from storage position in linkage
and insert in hole (K) to engage float springs.
Secure with hairpin.
m. Disengage lift cylinder stops.
n. Start engine and lower header fully.
o. Stop engine and remove key.
(continued next page)
B
E
G
H
D
K
J
F
