32
I
n
m
ore
d
etai
l...
1. Check that the track lock (9) and anti-kickback knob (8) are in the ‘0’ position.
2. Engage the saw in the track.
3. Rotate the track lock (9) in to the ‘I’ position.
4. Loosen the front and rear bevel lock knobs (4 and 12) and swivel the plunge
saw to the desired graduation. Tighten the both bevel lock knobs again.
(Refer to page 15 “Set cutting angle” section)
5. Rotate the mode selector (18) to free plunge position
or scribe mode
for a scribe cut. (Refer to page 21 “Mode selection” section)
6. Set the desired plunge depth. Ensure that the guide rail track compensation
(15) is in down position when using the saw with track. (Refer to page 13
“Set cutting depth” section)
7. To switch the saw on press the plunge lock button (1) and the ON/OFF
switch (2). Allow the blade to reach full speed, plunge the blade to your set
depth. Guide the saw forward to cut.
8. After completing the cut, release the ON/OFF switch and allow the blade to
come to a complete stop before removing the saw from the track.
Fig. 24
NOTE :
To prevent the saw from kicking back during plunge cuts
follow these steps: Hold the plunge saw in both hands and slowly
lower the saw blade. The cutting width indicators(19) shows the most
foremost and rearmost cutting points of the saw blade (Ø 165mm) at
maximum cutting depth and when using the track.
MSPS1200 by MACAllister
Product functions
Summary of Contents for MSPS1200
Page 42: ......
