25
2
Min.16mm
Fig. 16
MSPS1200 by MACAllister
Product functions
Straight cut (90°cut)
1. Loosen the front and rear bevel lock knobs (4 and 12) and swivel the saw to 0 °
position on the scale. Tighten the bevel lock knobs again. (Refer to page 15 “Set
cutting angle”section)
2. Rotate the mode selector (18) to free plunge position
or scribe mode
for a scribe cut. (Refer to page 21 “Mode selection” section)
3. Set the desired plunge depth. Ensure that the track compensation (15) is up
when using the saw without track. (Refer to page 13“Set cutting depth” section)
4. To switch on the saw press the plunge lock button (1) and the ON/OFF switch (2)
and push the motor down. Guide the saw forward to cut.
5. After completing the cut, release the ON/OFF switch and allow the blade to come
to a complete stop before removing the saw from the workpiece.
1
In
m
ore d
etai
l...
NOTE :
When operating the plunge saw at 90 , the mininum distance
between the tool and wall or workpiece perpendicular plane is 16mm.
(see Fig. 16)
Summary of Contents for MSPS1200
Page 42: ......
