14
MSPS1200 by MACAllister
Before you start
Using the track
= guide rail track compensation down.
Not using the track
= guide rail track compensation lever up. (Refer to Fig. 4)
2. Tighten the depth adjustment knob (14). The motor or respectively the saw
blade can now be pushed down to the set cutting depth.
For a clean, safe cut set the cutting depth in such way that only max. one saw
blade tooth protrudes under the work piece.
NOTE
The When accuracy is critical, use a set square not provided to
check the depth and make test cuts on a scrap piece of material.
NOTE
Maximum cutting depth for working without track can reach
59mm in special case if the track compensation lever is set in “down”
position. The real cutting depth is then 5mm more than the indicated
value on the scale. This setting shall only be applied if the ordinary
maximum cutting depth for working without track (54mm) shall be
exceeded on demand.
Get
ting
st
arted
...
15
Fig. 4
Fig. 3
16
14
Summary of Contents for MSPS1200
Page 42: ......
