mabe Centauro ICL2040 Series, Service Manual

Page: 81 / 138

9 | Manual de Servicio
Ingenieria de Servicio
MECHANICAL GUIDE
TO INSTALLATION
General indications
Quick connection guide for Laundry Centers
WARNING .
To reduce the risk of serious injury, follow
the instructions detailed in your product's installation manual
for proper operation. It is recommended that the connection
be made by a specialist, if your product is gas powered by a
plumber or in case your product is electric by a qualified
electrician and ensure that your installation is 220 V.
Required Tool:
Required Material:
* Depending on the location and installation of your product, the
required accessories may vary. Read your installation manual for more
details.
2 10” Adjustable
Wrenches
8” Steelson
Wrench
Mechanical
Wrench
Level
4 ”diameter metal
conduit
2 pcs 4 ”diameter
conduit clamps
Steel pipe
3/8 ”corrugated
(Gas dryer)
Teflon tape (Gas
dryer)
* 3/8 ”bell elbow
(Gas dryer)
* 3/8 ”bell nipple
(Gas dryer)
Installation requirements:
Location: It should be installed on a firm floor, not placed
on rugs or exposed to the elements or climatic factors. This
product should be placed in a ventilated area with an outlet to
the outside, free from obstruction, away from heat sources not
required for its connection.
Plumbing: It must have 2 water intakes, one for hot water
and the other for cold water, with a minimum water pressure
of 137 kPa and a maximum of 827 kPa. The water heater that
supplies the hot water in the home should be set so that the
water is between 120 ° and 150 ° F (50 ° and 66 ° C). Because
this product uses hot water for some wash cycles.
Drainage piping: The water can be drained into the riser
tube or configured tube. The discharge height shall not be less
than 30in (76cm), or no more than 6ft (1.8m) above the base
of the washer. The riser must be a minimum of 1-1 / 2 inches
in diameter and must be open to the atmosphere.
GAS LAUNDRY CENTER
Electrical requirement for GAS units:
If the product
is 127v / 60Hz it must be grounded, protected by a 15 or 20
Amp delay circuit breaker or fuse. If your product is 220V /
50Hz or 220V / 60Hz you will need to connect to an individual
branch circuit, protected by suitable time delay fuses or circuit
breakers. A 120 / 240v or 120 / 208v, 60 Hz, 30 amp single
phase four or three wire circuit is required. If the electrical
supply does not meet the above requirements, call a qualified
electrician.
Gas supply:
The supply line must have a ½ ”rigid pipe,
be equipped with a shut-off valve accessible within 6ft. (1.8m)
in the same room as the laundry center and have a gas
regulator. The gas pressure must be 2.75 kPa (11in C.A.) for
LP gas and 1.76 kPa (7in C.A.) in case of having natural gas.
Steps to connect your laundry center TO GAS:
1G.- Check your gas installation
Check that the product is designed for the same type
of gas that will be supplied at home
. If it is different,
contact the service to change the gas valve (LP / natural) at
the washing center
.
Flat head
screwdriver
Phillips
screwdriver
¼” Socket
Hood exhaust
The plug must withstand 30
Amps, and be specified at 250v,
in addition it must have the
shape of the contact of your
house
(Electric dryer)
4 ”metal
elbow