mabe Centauro ICL2040 Series, Service Manual

Page: 104 / 138

32 | Manual de Servicio
Ingenieria de Servicio
DISASSEMBLY
Drive or Transmission Assembly
To install the Drive Assembly to the Tub, the Shaft must
be slid through the hole in the Tub. Press the Tub Seal into
the hole of the Tub. Screw in the 16 screws in a crisscross
or zigzag pattern so that the Seal is pressed into the Tub
evenly and securely. This should be done by tightening
each screw approximately ¼ turn. The torque for these
Screws should be 75 +/- 10 in.lbf
Drain pump
Using pliers, disassemble the Pump Harness connectors.
Using a ¼” socket remove the 2 screws holding the Pump
to the Cabinet.
1
2
3
4
5
6
7
8
With pliers remove the Clamp from the Pump Hose.
Drain Hose
With Pliers, press and remove without cutting the 2 ties
that hold the Drain Hose to the Cabinet.
Drain Hose Cover
With a screwdriver or 1/4" socket, remove the screw that
secures the Cover to the Cabinet Back.