A
PPENDIX
: C
ONSOLE
S
ETUP
P
ROCEDURES
L
INK
THE
W
ORKSTATION
TO
THE
IR
94
M86 S
ECURITY
I
NSTALLATION
G
UIDE
Link the Workstation to the IR
The procedures outlined in this sub-section require the use of the CAT-5E cross-
over cable.
A. Plug one end of the CAT-5E crossover cable into the IR’s
LAN 2
port.
NOTE
: When facing the rear of the chassis, the LAN 2 port is the port on the right.
Portion of MSA chassis rear
B. Plug the other end of the CAT-5E crossover cable into the setup workstation’s
network card.
C. Connect the AC power cord to the back of the chassis and plug the cord into a
UPS power supply unit.
D. Power on the server by lowering the bezel and pressing the large button at the
right of the front panel:
Diagram of MSA chassis front panel, power button at far right
The Boot Up Process
The boot-up process may take 5 - 10 minutes. When the drive light remains off for
30 seconds, the system is booted up. (See the LED Indicators and Buttons section
for a description of front panel LED indicators and buttons.)
If you wish to verify that the unit has been booted up, you can perform the following
test on your workstation:
1. On a Windows XP, Vista, and 7 machine, go to your taskbar and click
Start > All
Programs > Accessories > Command Prompt
.
2. Type in
ping 1.2.3.4
3. Press
Enter
on your keyboard.
If you receive a reply, the unit is up.
Summary of Contents for MSA
Page 116: ...INDEX 110 M86 SECURITY INSTALLATION GUIDE ...
Page 117: ......
