LX Zeus v 3.4.3
10.9.2014
- 75 -
Note!
When the task has not been started yet, the statistics
data is limited to take-off and flight duration.
13.2.2
Statistics
The statistics page will open after press on STAT button.
Statistics page offers following statistics data:
Thermal analysis (1 and 2)
OLC
; calculation of OLC points
Baro
; shows baro trace from take off until present
position
Task
; presents task statistics data divided by legs
Route
; shows Task and distance flown
The statistics page colour structure can be adapted under
pilot personal requirements, after using of;
Setup/User
Interface/Statistics colours
End Flight
function will close the flig
ht, so don’t use it
during flight. After execution the flight will end and the flight
recorder (Colibri II) will be forced to close the flight.
13.2.2.1
Thermal Analysis
There are two pages of thermals statistics, which are
selectable by pressing the VARIO/FLARM push button:
Thermals 1
Thermals 2
Thermals 2
The page shows all thermals of the flight, as a reference
the actual MC setting is shown. The value corresponds to
thermal vario of individual climb. This means from entering
and leaving the thermal. The thermal is shown if you gain
at least 100 m of altitude. The dotted red line through the
columns shows the MC setting. This assists you in
determining a good MC setting.
Thermals 1
Every column means a thermal. The column is sliced into
various colours and widths. The colours are blue, yellow
and red. These colours depend on the current MacCready
setting. If the thermal strength is bellow MC setting, then
the column is blue, if it is above then the colour is red. The
yellow colour is around MC setting (plus / minus 20% of
MC).
Note!
If task consists of more than three legs, use
zoom
to
select legs of interest.