LXE 8650, User Manual

Page: 33 / 308

Introduction 21
E-SW-BLUESCANPG-A Bluetooth Ring Scanner Guide
Figure 1-17 Scanning a 2D Barcode
To scan with the imager, point the beam aperture at a barcode and press the Scan button. You will
see a bracketed crosshair strike the barcode. Align the brackets so that the center (or one of the
four corners of the center box) of the barcode is covered by the crosshair.
The scan On indicator illuminates (usually red) when the laser beam is on. Following a barcode
scan and “good read” the indicator usually turns green and the Bluetooth module beeps, indicating
a successful scan.
The laser and scan On indicator automatically turn off after a successful or unsuccessful read. The
scanner is ready to scan again.
Note: Whether there are beeps in conjunction with scan and decode functions is dependent on
the application currently running in the LXE Bluetooth capable mobile device. Beeps are
also emitted by the Bluetooth module, not the ring device.
Note: Decrease decode time by disabling unused barcode types. The ring scan engine can store
several different barcode symbologies at the same time. This means the system is able to
scan a Code 39 barcode, then an Interleaved 2 of 5 barcode, then a different barcode
without requiring a parameter reset.