LXE 8650, User Manual

Page: 193 / 308

SE4400 Imager Barcodes 181
E-SW-BLUESCANPG-A Bluetooth Ring Scanner Guide
Presentation Mode Session Timeout
This parameter, and the Presentation Mode parameter, are directed toward ring decoders that can
scan a barcode that enters its field of view, determine a good read/bad read, then scan again.
This parameter determines how long the ring decoder will attempt to decode a barcode before
determining if it is a good read or a bad read.
Presentation Mode means the ring decoder is always On and will scan barcodes that enter its field
of view.
Presentation Mode applies to Decode Mode only .
See also Trigger Modes .
Parameter Default Value: 2 Seconds
To set the duration of the attempt to decode a barcode detected in presentation mode, scan the
Presentation Mode Session Timeout barcode below.
Next scan three numeric barcodes from Imager Keypad Number Symbols to select a value between
1 and 255 that represents tenths of a second. Single digit numbers must have a leading zero.
For example, to set 0.5 seconds, scan the Presentation Mode Session Timeout barcode, then scan
the 0, 0, 5 barcodes from the section titled
Imager Keypad Number Symbols . To correct an error or
change the selection, scan the Cancel barcode and try again.