LXE 8650, User Manual

Page: 203 / 308

SE4400 Imager Barcodes 191
E-SW-BLUESCANPG-A Bluetooth Ring Scanner Guide
Prefix / Suffix Values
SE4400 imager engine prefix and suffix parameters cannot be set, changed, or reset using
the barcodes in this section.
See previous section titled Prefix / Suffix for an explanation.
Prefix (P) Parameter Default Value: Null
Suffix1 (S1) Parameter Default Value: LF
Suffix2 (S2) Parameter Default Value: CR
Note: Parameter “Scan Data Transmission Format” must be set before selecting Prefix/Suffix
values.
A prefix and/or one or two suffixes may be appended to scan data for use in data editing. These
values are set by scanning four barcodes (resulting in a four digit number) that correspond to key
codes for various mobile devices. See the table titled “ASCII Character Equivalents” at the end of
the “Appendix” for keycodes.
Prefix
To begin setting Prefix values, scan this Scan Prefix barcode:
Next, scan four numeric barcodes that correspond to the computer keycode using the “Imager
Keypad Number Symbols” at the end of this chapter.
If you wish to change your selection, scan Cancel on the “Imager Keypad Number Symbols” page.
Suffix 1
To begin setting Suffix 1 value, scan this Scan Suffix 1 barcode:
Next, scan four numeric barcodes that correspond to the computer keycode using the “Imager
Keypad Number Symbols” at the end of this chapter.
If you wish to change your selection, scan Cancel on the “Imager Keypad Number Symbols” page.