LV switch IPPBX8000, User Manual

Page: 27 / 199

LvSwitch IPPBX 8000 Manual
25
4. Step1: Connect the Ethernet cable to the Ethernet interface and another end to the device
5. Step2: When the power’s on please check the link indicator status. Once the link light’s on shows that the
connection is right.When the link indicator is off, please check the connection.

Please do not plug the phone line socket into any RJ45 network interface, or it will damage the device;
Use CE standard Ethernet cable with RJ45 connector.
2.8.2 Connect FXS/FXO port
The FXS/FXO port is with RJ45 interface, and the 1-channel RJ45 interface corresponds to the
4-channel RJ11 interface on the side of terminal equipment. Among them, PIN1 and pin2 of RJ45 are 1-way
phone, PIN3 and 4 are 1-way phones, PIN5 and 6 are 1-way phones, and PIN7 and 8 are 1-way phones.
2.8.3 Connect E1/T1 interface
The E1/T1 interface of the ippbx is RJ45 ,connect with 120
Ω
balanced twisted-pair cable. The cable
material of E1 wire is five kinds of network wire and super five kinds of network wire, and the two ends are
pressed together with RJ45 plug. The E1 cable configured for the equipment is the crossed E1 wire, cable
model E1-120ohm.
E1 line can be divided into cross line and straight line.
2.8.3.1 Intersection line
Cross wires are generally used to connect devices of the same level. When the E1 interface of the
opposite end device is also the RJ45 interface, cross E1 wires of 1, 4, 2 and 5 shall be used to connect. The
specific wiring relationship is shown in the following table.
Table 2-3 Cross line
A end Cable chromatography B end
1 White and orange 4
2 Orange 5
4 White and green 1
5 Green 2
2.8.3.2 Straight line
Straight line is generally used to connect with the superior equipment. If the E1 interface of the superior
equipment is also the interface of RJ45, the straight line is adopted. The specific wiring relationship of the
direct line E1 is shown in the following table:
Table 2-4 Straight line
A end Cable chromatography B end