luxul.com | 357 South 670 West | Suite 160 | Lindon, UT 84042 | p: 801-822-5450 | f: 801-822-5460
User Guide
15
Ethernet cable length of up to 300 feet can be used. DO NOT yet apply power to
the POE injector or switch.
NOTE:
To ensure FCC compliance and minimize high frequency noise, a
Ferrite Noise Suppresser is included with the POE injector kit. It
should be placed on the Ethernet cable at or near the connector
on the end of the Ethernet cable that plugs into the POE device.
To install it, simply unsnap the plastic fasteners, place it on the
Ethernet cable as demonstrated below and re-snap the plastic
fasteners to secure it in place.
4.4.6 Connecting to the Internet Source
Note that the Luxul device is not a router and in most installations will be con-
nected to a Router or Switch in order to deliver Internet access. To do so, connect
the POE injector (or switch) to the desired Internet source using another Ethernet
cable. Be sure the source device is powered off.
Data
Source
Power
Source
Data
In
Power
In
Data/Pwr
Out
POE
Injector
Ferrite Noise
Suppresser
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.4.7 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE:
If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
