User Guide
14
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
XAP-1032 with Antennas mounted above. Actual cables are longer
NOTE:
If desired and optimal for placement and installation, longer
Coax cables may be used. It is recommended to keep cable
lengths as short as possible and to use low loss cable in order to
minimize cable loss. Contact Luxul for additional cable options.
CAUTION:
Coax cables must be exactly the same length or the XAP-
1032 will not function properly
4.4.4 Connecting the Ethernet Cable
With the XAP-1032 and antennas properly mounted and installed, you can now plug
the Ethernet Cable into the RJ-45 connector.
NOTE:
Category-5, super Category-5 or Category-6 unshielded twisted
pair (CAT5/CAT5e/CAT6 UTP) cables can be used. For best
results, it is recommended that Category-6 shielded twisted pair
be used to ensure stable data transmission at highest data rates.
4.4.5 Connecting to the Power Source
The XAP-1032 is POE ready and supports Legacy (48v 1a), 802.3af, and 802.3at
POE injectors. A POE injector is included with the device. To apply power, simply
connect the opposite end of the Ethernet cable to which the access point is
already connected to the provided POE injector or other POE switch or injector. An
