Optional Fan Kit
Each kit contains:
-Fan assembly with mounting gasket
-Grounded electrical harness
-Reostate & thermal switch
Caution: The appliance contains many sharp edges. Make sure to wear proper gloves.
1. Shut off any electrical to the unit if applicable.
2. Remove lower louvre grills:
-Remove 2 fasteners
-Lift up and remove from lower valve compartment.
3. Make sure the wire terminals are secured to the fan assembly.
4. Carefully slide fan assembly with gasket in from left side of valve compartment behind gas
valve assembly.
5. Secure fan assembly with supplied fasteners using the holes in the rear of the unit wall.
6. Secure thermal switch into the support provision located at the bottom of the firebox
7. Install fan speed adjustment knob with wires facing down.
Attack lock nut & control knob.
8. When the final installation check is complete, insert three pronged plug into receptacle
provided at the left side of the unit.
9. Replace lock fasteners and restore to operation.
Page 14
Double fan kit shown.