Lighting Instructions
For your safety, read the following before lighting.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage and personal injury or death.
Page 19
A. This appliance has a pilot which must be lighted
by hand. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
-Do not try to light any appliance.
-Do not touch any electric switch; do not use any
phone in your building.
-Immediately call you gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
-If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas or
control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it, call a
qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and replace any
part of the control system and any gas control
which has been under water.
1. STOP! Read the safety information above on this
label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove louvers.
5. Push in gas control knob slightly and turn
clockwise to “OFF.”
Note: knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
6. Wait five minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow “B” in the safety information
above on this label. If you don’t smell gas, go to the
next step.
7.Turn knob on gas control counterclockwise to
“PILOT”
Lighting Instructions
8. Push in control knob all the way and hold in.
Immediately push in piezo ignition button. Continue
to hold the control knob in for about one minute
after the pilot is lit. Release knob and it will pop
back up. Pilot should remain lit. If it goes out,
repeat steps five through 8.
-If knob does not pop up when released, stop
and immediately call your service technician or gas
supplier.
-If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your service
technician or gas supplier.
9. Turn gas control knob counterclockwise to “ON.”
10. Replace louver panel.
11. Turn on all electrical power to the appliance.
12. Set the thermostat to desired setting.
To Turn Off Gas to the Appliance
1. Set the thermostat to lowest setting.
2. Turn off all electrical power to the appliance if
service is to be performed.
3. Remove louvers.
4. Push in gas control knob slightly and turn
clockwise to “OFF”. Do not force.
5. Replace louvers.
SIT VALVE DESCRIPTION
1. Control Knob
2. High Low Knob
3. Pilot Adjuster
4. Thermocouple Tap
5. Main Operator
6. Manifold Pressure Tap
7. Supply Pressure Tap
8. Pilot Tap
9. Manifold Tap
10. Flange Securing Screws
11. Thermoelectric Unit
12. Additional Valve Mounting
