English
- 18 -
output differently to normal and widescreen TV
sets.
• This function defines the screen format of the
connected TV to enable broadcasts’ being displayed
correctly.
• Select
4:3
if you have a standard TV set with 4:3
aspect ratio.
• Select
16:9
if you have a widescreen TV.
Note
: This function also enables you to change TV
Type that you have previously selected during the
rst time installation.
TV Out
• The set-top-box can output RGB and CVBS signal
via the
TV SCART
connector located on the rear
panel.
• Although the RGB format provides a better picture
quality, some devices might not support it.
Receiver Upgrade
• To ensure that your set-top-box always has the most
update information, you can use this setting. In order
for the proper operation, please ensure that the box
is set to standby mode.
•
The STB automatically powers up at 3.00 A.M. every
day and searches for any new software that may
be broadcast. If found, the box will download new
software automatically. This operation will normally
take approximately 30 minutes.
• You can enable or disable automatic upgrade by
setting
Automatic Scanning
option.
• You can manually search for new software by
selecting
Scan for upgrade
.
Menu Locking
• This setting con
gures menu locking.
• Select Menu Locking option by using “ ”/“ ” buttons.
• Press
OK
button to enter the menu.
• To display parental lock menu options, PIN number
should be entered. Factory default PIN number is 0000.
After coding the correct PIN number, parental settings
menu will be displayed:
Menu Lock
• Menu lock setting enables or disables the menu
access. You can disable access to the installation
menu or the whole menu system.
Set Pin
• Press
OK
to display the “
Set PIN
” window. Use
numeric buttons to enter the new pin number. You
will need to input your new pin a second time for
veri
cation purposes.
• The factory default pin number is 0000. If you change
the pin number make sure you write it down and
keep it safe.
Low Power
If you enable low power option, low power mode will be
activated. In low power mode the power consumption
is less then 1W (in standby).
If you disable low power option the power consumption
will be higher than 1W in standby mode however the
opening time will be shorter.
Auto Standby
• Press “ ” or “ ” button to select Auto Sleep. Use “
” or “ ” button to set the Auto Sleep to
Disabled,
2 Hours, 4 Hours, 6 Hours
or
8 Hours.
• After the timeout value is reached, the box will
switch off.
System Info
Select
System Info
and press
OK
button to display
system information.
