English
- 20 -
•
Ensure that you back-up important recordings
onto Video or DVD before formating the HDD.
• Press
OK
when the
Format Disk
option is
highlighted. A menu appears, requiring you to enter
the pin number. If you have not changed the pin
number, the factory default is 0000.
• After you enter the correct PIN code, a pop-up menu
appears on the screen to ensure that the hard disk
should be formatted.
• Select
YES
and press
OK
to format the hard disk.
Select
NO
and press
OK
to cancel.
First Time Installation
• If you want to load default settings of your set-top-
box, you can perform
rst time installation.
• Select
First Time Installation
by using “ ” or “ ”
button and press
OK
button.
• The following message, asking you whether or not to
delete all channels and settings, will be displayed.
• Highlight
No
by using “ ” or “ ” button to cancel
installation.
• Highlight
Yes
by using “ ” or “ ” button and press
OK
button
to start
rst time installation.
• After you select
Yes
, factory settings will be loaded.
• Installation wizard will guide you through the
installation process. See the section, “
First
Time Installation
” in previous chapters for more
information on this process.
OSD
Warning Messages
HDD Initialisation
Whenever you switch your set-top-box on, the
following status OSD will be displayed. This status
OSD will remain on the screen for a short while. This
OSD means that the hard disk is initialised.
No Signal
• When the box receives no signal (e.g. the antenna
cable is disconnected), “
NO SIGNAL
” message will
be displayed on the screen.
No Channels Have Been Added Yet
• When there are no channels stored in the box,
Channel List menu will not be displayed and channel
navigation will not be available.
• In such cases, the following error message will be
displayed.
