![background image](http://html1.mh-extra.com/html/lutron-electronics/qsgr-16d/qsgr-16d_quick-installation-and-operation-manual_1950660016.webp)
®
GRAFIK Eye
®
QS with DALI Quick Installation and Operation Guide 16
For additional information, see the complete installation and operation guide at
www.lutron.com/qs
Lutron’s wireless Radio Powr Savr
TM
daylight sensors can be associated with the
GRAFIK Eye
QS Wireless to adjust light levels when certain daylight levels are detected.
This section applies to installations where the
GRAFIK Eye
QS Wireless is being used in
a single-room wireless installation.
To associate wireless daylight sensors and
GRAFIK Eye
QS Wireless control units:
1. Make sure the wireless mode of the
GRAFIK Eye
QS control unit
is “Enabled” (see page 10).
Note:
To properly save the wireless mode, exit and then re-enter
programming mode before associating wireless daylight
sensors.
2. Enter programming mode (see page 9).
3. Use the Master buttons to highlight “Sensor setup” and press
the OK button to accept.
4. Use the Master buttons to highlight “Add wireless sensors” and
press the OK button to accept.
5. Press and hold the “Link” button on the front of the daylight
sensor until the sensor starts flashing. The info screen on the
GRAFIK Eye
QS will display the sensor’s serial number.
6. Press the OK button on the
GRAFIK Eye
QS control unit. A
screen will confirm that the sensor has been assigned.
7. Repeat the above steps for all desired sensors.
8. Exit programming mode (see page 9).
To disassociate wireless daylight sensors and
GRAFIK Eye
QS
control units:
Refer to the
Radio Powr Savr
daylight sensor install guide to return
the sensor to its “out-of-box” functionality . Doing so will remove
its programming from the
GRAFIK Eye
QS control unit.
Note:
The wireless signal has a range of 10 m (30 feet) through
standard construction.
Associating Wireless Daylight Sensors and GRAFIK Eye
®
QS Wireless Control Units
(for wireless enabled units only)
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
Master
buttons
OK
button
Timeclock
(back) button
Main menu
Zone Setup
Sensor Setup
Daylight
SN: xxxx-xxxx:
press OK to Save
Add wireless sen
Initiate association
of sensors
Saved
*Assigned*
Sensor Setup
Daylight
Add wireless sensors
Link
button