![background image](http://html1.mh-extra.com/html/lutron-electronics/grafik-eye-qsgrj-4p/grafik-eye-qsgrj-4p_programming-addendum_1950625005.webp)
To use the
Pico
wireless controller as a zone controller with a
GRAFIK Eye
QS Wireless control unit:
1. On the
Pico,
press and hold the top (on) and bottom (off) buttons for 3 seconds. The LED on the
Pico
will
flash slowly, and the scene buttons LEDs on the
GRAFIK Eye
QS will all flash.
2. On the
GRAFIK Eye
QS, the info screen will ask for confirmation that you wish to change the type; press
the OK button. Use the master buttons on the
GRAFIK Eye
QS to select “Zone”. Press OK to save.
3. To assign a zone on the
GRAFIK Eye
QS to the
Pico
, use the zone raise/lower buttons for that zone to set
the desired preset level, then press and hold the zone raise and lower buttons simultaneously for 1 second
(until the LEDs flash at the programmed preset level).
To unassign a zone on the
GRAFIK Eye
QS to the
Pico
, while the zone LEDs are flashing, press and hold
the zone raise and lower buttons simultaneously for 1 second (until the LEDs stop flashing and the 3
middle LEDs light).
Repeat this step to assign levels for all desired zones to the
Pico
control. Zones assigned to the Pico will
have all LEDs flashing in unison, and zones not assigned will have the 3 middle LEDs lit.
4. On the
Pico,
press and hold the top (on) and bottom (off) buttons for 3 seconds. The LED on the
Pico
and
the LEDs on associated
GRAFIK Eye
QS Wireless control units will stop flashing.
Functionality of the
Pico
control when programmed as a zone controller:
Top button:
All assigned zones go to 100%
Center round button:
All assigned zones go to the programmed preset level
Bottom button:
All assigned zones go to Off
Note:
The wireless signal has a range of 30 feet (10 m) through standard construction.
Wireless System Programming
R
GRAFIK Eye
®
QS Wireless System Programming
Light
On
Adjust
Off
Change type?
Zone
Saved
Saved
Pico
Change type?
Press OK
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
On the
GRAFIK Eye
QS control
unit, press and hold the top scene
button for 3 seconds to associate,
or press and hold the bottom
scene button for 3 seconds to
disassociate with the
Pico
control.
Associate
OR
Disassociate
Info
screen
Associating Pico
TM
Wireless Controls and
GRAFIK Eye
QS Wireless Control Units
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
Zone LEDs
Zone Raise
Zone Lower