© PROPERTY OF LUNDIX IT SWEDEN, ALL RIGHTS RESERVED – THIS DOCUMENT AND THE INFORMATION CONTAINED THEREIN ARE CONFIDENTIAL – THE DISCLOSURE OR OTHER COMMUNICATION, COPYING, REPRODUCTION
AND ANY USE WHATSOEVER IS FORBIDDEN WITHOUT THE WRITTEN AUTHORIZATION OF LUNDIX IT.
SPC Bridge KNX User Manual
Revision
1.0
Page
14 of 25
Reference
2020-111
4.6
KNX Datapoints
Interface -> KNX Datapoints
shows the current values of the KNC communication objects and can be
used for troubleshooting. The objects are divided in following categories:
System objects
SPC Area States
SPC Zone States
SPC Zone Status
SPC Commands
Element
Description
Hide unused datapoints
If this is checked, only datapoints that have been accessed (from SPC side) is shown.
Datapoint #
Datapoint address
Description
Datapoint description
DPT
KNX data type
Value
Current value
KNX Update Status
Access status reported from the KNX interface.
OK: The value was successfully sent to KNX bus
Not connected Group Address: Datapoint is’nt linked to a Group Address (by ETS)
Other possible error status (should’nt normally appear) :
Internal Error, Not found, Buffer Error, Write Error, Unsupported, Invalid service, Invalid
command, Invalid length, Invalid message, Busy, Failed request
Last update
Last time the value was updated from the SPC system.
4.7
System Info
System -> System Info
shows some basic information about the SPC Bridge hardware and software.
