Lumenis
®
Pulse
TM
50H / 100H Laser Systems
Professional Maintenance
UM-20006520DE, Rev. A
Page 63
Professional Maintenance
This section covers checks, calibrations and maintenance that require
internal access to the laser system’s console and special skills.
CAUTION:
The Lumenis Pulse 50H or 100H laser system may only be serviced by
Lumenis certified field service engineer using an approved service
manual.
WARNING:
These procedures assume specific knowledge, training and use of tools
not available to repair personnel outside of Lumenis. Since performing
these procedures may expose the user to potential electrical and laser
energy hazards, Lumenis requires that these procedures only be
performed by trained service personnel.
Energy Detectors Calibration
Energy detectors check and calibration must be performed by an engineer
or technician qualified to work with laser equipment. Questions regarding
this procedure should be referred to Lumenis Customer Service.
DISCLAIMER:
Calibration is a service procedure to be done only by Lumenis-certified
service engineers or customers who have taken and passed a Lumenis
Service Certification Training course. Adjustment by anyone other than a
trained Lumenis service engineer or a certified customer voids any
existing manufacturer’s warranty on the instrument. A service manual for
the laser system may be purchased from Lumenis. It is company policy
not to distribute service tools outside of the Lumenis service organization.
Possession of service instructions or tools does not authorize repair or
modification of a Lumenis instrument by uncertified personnel.
The Lumenis Pulse 50H or 100H system incorporates internal energy
detectors which are used to control lasing energy. The energy detectors
check compares the internal energy reading to the reading from a
calibrated external power meter
