![LUMENIS Novus Spectra Operator'S Manual Download Page 22](http://html1.mh-extra.com/html/lumenis/novus-spectra/novus-spectra_operators-manual_1948101022.webp)
Novus Spectra
0642-543-01, Rev A, 12/02
22 General Operation
Laser Console Basics
Turning on the laser
1
Insert the key into the keyswitch.
2
Turn the key to the | (on) position.
3
A laser self-test and warmup begin and the display screen will show a line of
dashes. The self-test and warmup take approximately one minute. When the
warm-up is successfully completed, the display screen will show Stdby
to
indicate that the laser is in standby mode.
Depressing the footswitch during warmup will disable the footswitch.
If any fault conditions are encountered during the laser self-test and warmup,
refer to the “Troubleshooting Guide” in the Maintenance chapter.
Restarting the laser
In most cases you will not need to restart the laser. If a condition occurs that
requires you to restart the laser:
1
Turn the keyswitch to the (off ) position; wait 5 seconds.
2
Turn the keyswitch to the (on) position. The laser begins the routine start-up
sequence.
Keyswitch
Summary of Contents for Novus Spectra
