N32O
User's manual
27
•
Active individual characteristic.
Configuration parameters:
•
SCAL
– selection of the operation to be performed on the counted number of
pulses of the meter. Possibility to select division or multiplication by the value
defined by CONSt parameter.
•
CONSt
– defines the value by which the counted basic number of pulses will be
multiplied or divided. If CONSt value is less than zero the basic counting direction of
the counter is set to down counting.
•
CAUTO
– for basic up counting direction (CONSt > 0) it defines the value up to
which the counter will count. For the down counting direction (CONSt < 0), it defines
the initial value set after the counter reaches zero or the value after resetting the
counter. It is important when setting CAUTO parameter that the setting value should
be the value that the counter will reach before the conversion by the mathematical
functions and the individual characteristics (CONSt setting value is automatically
taken into account by the meter).
•
tL
– minimum duration in microseconds of the low input level (inactive state) before
it is considered as the low level. Low level filtering is active for tL setting higher than
50.
•
tH
– minimum duration in microseconds of the high input level (active state) before
it is considered as the high level. High level filtering is active for tH setting higher
than 50.
•
bCtrL
– permission to control the counter using the meter keypad. The control
functions using the meter buttons are enabled for ON setting. The following
operations can be done using the keypad: start/stop counting, counter reset.
•
SAVG
– the setting defines for the counter mode only data acquisition period for the
averaging algorithm using the moving window method. The setting defines the
multiplicity of 100 milliseconds, e.g. data acquisition period is 1000 ms for the
setting 10.
•
MAVG
– number of the measurements with a period based on SAVG setting defines
the time interval in which the minimum and maximum value will be determined.
Counting the average value using the moving window method in the counter mode
is not available.
•
MatH
– type of the mathematical operation converting the value of counted pulses.
The user can select the type of operation or disable the function by selecting
NONE
setting.
•
CFtIM
– not applicable.