13
Install the nut on the inside of the round post to secure the pulley. Using a 16mm wrench to hold the nut, tighten the
bolt.
Insert the bolts into the back plate as shown in above left image. Align the square post holes with the corresponding
black top cross support holes. Tighten using an 18mm socket.
Place the measuring scale bracket as shown above and insert bolts and nuts. It is important to alternate tightening of
the nuts (top then bottom) to ensure the black round clamp begins to compress evenly on both the top and bottom until
flanges meet at outer edge. Tighten nuts using a 13mm socket.
Install the square indicator rod to the sawmill using the two bolts and tighten using a 10mm socket.
Summary of Contents for BSW66GL
Page 2: ......
