21
#3 – BLADE GUIDE ADJUSTMENT
Never attempt the below with the engine running. As a safety precaution, remove the spark plug cap. It is also advised
to confirm that the blade is tracking properly before performing the below. Blade tracking is covered in the previous
page.
Using a 6mm allen key, loosen the blade guide blocks on both the left and right sides. They should be free to slide up
and down.
Loosen the blade guide assembly bolt with a 16mm socket. The round shaft should now be free to slide back and forth.
Position it so that there is a paper width gap between the bearing and the back of blade. Tighten bolt against the flat on
the shaft to secure assembly back in position.
Using a piece of paper in between the blade and blade guide blocks, tighten the allen key bolts.
*Now that your sawmill is ready for cutting, please refer the following instructions-“Run your saw”- in the
following section to enjoy your log-cutting at home.
Summary of Contents for BSW66GL
Page 2: ......
