46
47
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
WHAT YOU SHOULD DO
A light
flash is not
emitted
when I press
the FLASH
BUTTON.
The CONTACT
SENSORS
are not in full
contact with the
skin.
Check that both CONTACT SENSORS are touching
your skin. The LumaRx Full-Body Hair Removal
System won’t work unless it’s flat against your skin.
See pages 34-35 for this situation.
You have not
waited enough
time between
flashes for
the LumaRx
Full-Body Hair
Removal System
bulb to recover.
The LumaRx Full-Body Hair Removal System requires
about 3-4 seconds to recover between flashes. When
your LumaRx Full-Body Hair Removal System is
ready to flash (and assuming the CONTACT SENSORS
are flush against the skin), the device will “CHIRP” to
confirm that it is ready to flash. See pages 34-37 for
this situation.
The LAMP
CARTRIDGE has
flashed 65,000
times and needs
to be replaced.
You should see
the Light Bulb
flashing YELLOW.
Make sure that the BULB LIFE LIGHT is either solid green
or solid yellow. If it is flashing yellow, disconnect the
LumaRx Full-Body Hair Removal System and replace
the LAMP CARTRIDGE. Refer to “Replacing the LAMP
CARTRIDGE” on page 41.
PROBLEM
POSSIBLE
CAUSE
WHAT YOU SHOULD DO
The
“hourglass”
icon is
flashing
yellow and
the LumaRx
Full-Body
Hair
Removal
System is
beeping
The LumaRx
Full-Body
Hair Removal
System hand
piece needs
some time to
cool down.
Wait for a few minutes for the LumaRx Full-Body
Hair Removal System to cool down. There is no need
to shut the unit down, as the hourglass icon and
beeps will turn off when the LumaRx Full-Body Hair
Removal System is ready to use again.
