34
35
STEP 5: TREAT YOUR SKIN
The LumaRx Full-Body Hair Removal
System can flash approximately every 3
seconds (with the Body Treatment Cap)
and is ideal for treating both larger and
smaller areas.
Periodically, if either the hand piece or
base unit gets too hot, the “Hourglass”
icon will flash and the unit will beep.
Wait for a few minutes to allow the
LumaRx Full-Body Hair Removal System
to cool down. There is no need to shut
the unit down, as the hourglass and
beeps will turn off when the LumaRx
Full-Body Hair Removal System is ready
to use again. The number of flashes
delivered before the cool down state
depends on several factors, including
how fast you apply the treatments, and
the room temperature. See Figure 5.
5a.
Ensure that the ENERGY LEVEL is
on the correct setting (See “Choose
Energy Level” on page 31 for details
about the different settings).
5b.
Apply the treatment cap to the skin,
making sure the skin is spread
evenly and smoothly. Make sure the
CONTACT SENSORS on the treatment
cap are in full contact with the skin.
SKIN CONTACT SENSORS
5c.
If the CONTACT SENSORS are NOT in
full contact with the skin, the device
will not operate if you press the
FLASH BUTTON and it will “BUZZ.”
Double check that the contact sensors
are in full contact with the skin.
5d.
If the CONTACT SENSORS on the
treatment cap are in full contact with
the skin, LumaRx will “CHIRP”
indicating the device is OK to flash.
5e.
Press the FLASH BUTTON. The device
will flash a pulse of light onto your
skin. You will see a flash of light and
simultaneously hear a sound, which is
normal for the device. You may feel a
mild sensation of warmth and tingling.
Figure 5
OPERATING INSTRUCTIONS
