32
33
LEVEL SETTING BUTTON until the desired
lower energy setting is set. After reaching
Level 5, pressing the ENERGY LEVEL
SETTING BUTTON an additional time will
reset to Energy Level 1.
As with any new skin care product, we
recommend testing the LumaRx Full-Body
Hair Removal System on a patch of skin
before your first full treatment or before
treating a new area.
STEP 4: TEST A PATCH OF SKIN
Testing the LumaRx Full-Body Hair
Removal System helps you determine the
appropriate Energy Level to use the first
time you use the device, or for each new
treatment area. Higher Energy Levels are
more effective at removing hair, but may
be less comfortable. To get the best results
Energy Level
1
2
3
4
5
Press Energy
Level Setting
Button
Defaults to Level
1 upon start-up.
Energy Level
Selection Display
Lights:
3a
. Upon start-up, the device sets itself to the
lowest energy level (Level 1 above). The
device is now ready to trigger the first
flash. (See “Using the LumaRx Full-Body
Hair Removal System”).
3b
. To change the energy level press
the ENERGY LEVEL SETTING BUTTON
to increase the energy level until the
desired energy level is set (for example,
pressing the ENERGY LEVEL SETTING
BUTTON once will increase from Level
1 to Level 2; pressing another time will
increase to Level 3). ENERGY LEVEL
INDICATOR LIGHTS will coincide with
the energy level setting.
3c
. If a higher energy level was previously
selected and a lower energy level is
desired, continue to press the ENERGY
with the LumaRx Full-Body Hair Removal
System, you should use the highest Energy
Level setting that’s comfortable and does
not cause an adverse skin reaction.
To test the LumaRx Full-Body Hair Removal
System on a new treatment area, follow
these steps:
Start at Energy Level 1.
The LumaRx
Full-Body Hair Removal System defaults to
Energy Level 1, which is where you should
start the Patch of Skin Test.
Flash your Skin (see pages 34-37).
With the LumaRx Full-Body Hair Removal
System at Energy Level 1, treat your skin
with one single flash by firmly placing
the flash window flat against skin (you
should hear a “CHIRP” and the
SKIN TONE
SENSOR
light should be GREEN). Press the
FLASH BUTTON
to deliver a flash.
Mild to moderate discomfort is normal. If
you feel more than moderate pain, stop
using the LumaRx Full-Body Hair Removal
System immediately and call Customer
Service (see page 51) for help.
• If a flash delivered at Energy Level 1
feels tolerable, press the ENERGY LEVEL
button once to change to Energy Level 2.
Move the device to a different spot and
flash the LumaRx Full-Body Hair Removal
System one more time. Repeat this
process until you find the highest setting
that feels right for you.
• Wait 24 hours and then look at the
test areas. If the skin appears normal,
proceed with your first full treatment at
the highest setting. Record this level in
your Treatment Cards on pages 56-58.
If you notice blistering, burns, changes
in your Skin Tone, or any other side effects,
or if you are not sure about the outcome
of the test, DO NOT USE the LumaRx Full-
Body Hair Removal System and contact
Customer Service page 51 for assistance.
Repeat the test if you decide to try the
LumaRx Full-Body Hair Removal System
on a different part of the face, or if your
skin tone has changed (for example, from
a sun tan).
Figure 3
OPERATING INSTRUCTIONS
