38
39
OTHER TREATMENT TIPS
• Perform your treatments at night before
going to bed, so that any lingering
redness will most likely disappear by
the morning.
• If you’ve waxed hair in the treatment
area, wait 6 weeks before using the
LumaRx Full-Body Hair Removal
System. The device uses the hair under
your skin to disable your hair at the
root, so it is not effective if the hair has
been pulled out.
• Shave immediately before treating the
area. Doing this will let you use a higher
Energy Level, because there will be
less hair to heat up and the treatment
will sting less. How well you shave
will make a big difference in how the
treatment feels. See page 27.
• Periodically, if the device gets too hot,
the “Hourglass” icon will flash and the
unit will beep. Wait for a few minutes
to allow the LumaRx Full-Body Hair
Removal System to cool down. There
is no need to shut the unit down, as
the hourglass icon will disappear when
the LumaRx Full-Body Hair Removal
System is ready to use again.
• The number of flashes delivered before
the cool down state depends on several
factors, including how fast you apply the
treatments and the room temperature.
• Use the highest Energy Level setting
that’s comfortable for you and that does
not cause an adverse reaction. Higher
Energy Levels are more effective. See
page 31.
OPERATING INSTRUCTIONS
USER-MAINTENANCE INSTRUCTIONS
When your LumaRx Full-Body Hair
Removal System session is over, we
suggest the following:
• Be sure to record your treatment in
the Treatment Cards on pages 56-58.
• Turn the LumaRx Full-Body Hair
Removal System off by pressing the
POWER BUTTON.
• After each hair removal session, clean
your LumaRx Full-Body Hair Removal
System, especially the CAP and LIGHT
WINDOW (See “Cleaning the LumaRx
Full-Body Hair Removal System”).
• After cleaning, store your LumaRx
Full-Body Hair Removal System in
its original box and keep it away
from water.
CLEANING the LumaRx Full-Body Hair
Removal System
After each session, clean your LumaRx
Full-Body Hair Removal System, especially
the LIGHT WINDOW, the CONTACT SENSORS,
and the SKIN TONE SENSOR window.
DO NOT
place any part of the LumaRx
Full-Body Hair Removal System in water
or other liquids. If any part of the LumaRx
Full-Body Hair Removal System gets wet,
DO NOT USE. Contact Customer Service
on page 51 for help. As with any electrical
device, a wet LumaRx Full-Body Hair
Removal System could cause electrocution
or electric shock.
• Make sure the LumaRx Full-Body Hair
Removal System is turned off. Remove
the POWER CORD from the device and
wall socket before cleaning.
• Use a clean, lint-free cloth (one is
provided with the unit) or a cotton swab
to gently wipe the LumaRx Full-Body Hair
Removal System surface and especially
the CAP, LIGHT WINDOW, CONTACT
