ENGLISH
17
Note:
POLICLEAN must be used to guarantee an optimal interior cleaning. 1l bottles of cleaning alcohol can
be obtained from your specialty retailer. Clean the outside of the device with a moist cloth and dry it
afterwards. More severe contaminations should be removed with a commercially available stainless
steel cleaner.
ATTENTION!
>
Neither the inside nor the surface of the machine must be subjected to a gush of water, because
water penetration can damage the electronics. Under no circumstances must the machine be cleaned
with jet water (hose) or a high pressure cleaner. Do not use abrasives, acids, lyes, steel wool or steel
brushes for cleaning, because the machine would be damaged by these materials. Objects must not
be placed on the machine!
>
The flatware polishing machine will be heated to app. 115 °C. Let the machine cool down for a few
minutes before you start cleaning the inside of the machine. During operation, please do not
perform any grabbing actions into the inside of the machine or into the polishing granulate.
17.2 POLISHING GRANULATE EXCHANGE
The polishing granulated must be exchanged regularly to guarantee an optimal polishing result (the
granulate becomes too fine or dirty). The following message will be shown on the display.
This message will be displayed after 150 operating hours and a
polishing granulate exchange must be performed to guarantee
an optimal polishing result. The machine continues to run,
however, no other message will be displayed. This message is
shown permanently until a polishing granulate exchange has
been performed.
1.
Prepare a small shovel or a glass, an empty bucket and a vacuum cleaner.
2.
Open the cover.
3.
Press the START/STOP button for 8 seconds. The vibration motor starts to vibrate despite the fact
that the UVC lamp has not been switched on.
4.
Release the START/STOP button after 8 seconds. You have 3 minutes for the exchange before the
vibration process is completed. If you need more time, repeat the pressing of the button for 8 seconds.
5.
Remove the larger part of the polishing granulate with the shovel and the rest by using a vacuum cleaner.
6.
Spray the vibration container and the perforated grid with POLICLEAN cleaning alcohol (article
number 208ZB00002) and dry it with a clean paper towel.
7.
Fill the machine with app. 3.5 kg POLIDRY polishing granulate (article number 204ZB00002) and
close the machine cover.
8.
Let the machine run for 1 hour (without flatware) and remove the generated dust at the vibration
container and underneath the flatware insertion mat (with cleaning alcohol). Repeat the process
before you fill the machine with flatware
