EN
LUCTRA | 19
English
Connecting the electrics
Note:
The number of connecting cables depends on the VITAWORK
®
variant.
Note:
Depending on the design, each connection cable fits into one connector!
– Connect the connecting cables to the lamp head.
– Use the screw (13) to attach the access panel (10) at the top of the lamp head (1).
LUCTRA
®
VITAWORK
®
with low power device connection
– Insert the mains cable as shown.
– Insert the plug into the socket.
– Switch the lamp on or off using the on-off switch (8).
LUCTRA
®
VITAWORK
®
CLAMP
– Insert the plug into the socket.
Align the lamp head
– Use a spirit level to check the horizontal alignment of the lamp head.
– Align the lamp head by screwing in/unscrewing the hexagonal socket-head screws (12).
– Turn the threaded pin (11) away from it.
Operation
NOTICE!
Risk of property damage!
The lamp head is designed in such as way that the LEDs can be ideally cooled, thus
achieving a long service life.
Never cover the lamp head. This may cause a fire hazard.
14. On-Off touch button
– Tap the On-Off touch button to switch the light on or off.
15. Sensor buttons are used to adjust the direct luminosity (5 levels)
16. Sensor buttons are used to adjust the indirect luminosity (5 levels)
– Tap the / touch button to reduce the light intensity.
– Tap the / touch button to increase the light intensity.
– Keep the sensor buttons pressed to continuously change the luminosity.
17. Sensor button for the presence sensor
18. Sensor button for the luminosity sensor
Note:
Luminosity and presence sensors depend on the VITAWORK
®
variants present.
Summary of Contents for VITAWORK
