8D1
8D2
9A
16
Tools Required
- Dashboard (D)
- Dashboard Reference
Card (E)
- Omni Dashboard
Bracket (J)
- 3mm Allen Wrench
- Phillips P1 Screwdriver
- M5 x 8mm Hex Screw (O)
- 4-40 x 3/16 Phillips
Screws (P)
STEP 8D - OMNI ALTERNATIVE DRIVE
Choose the correct (left or right) Dashboard Reference Card (E). Use four 4-40 x 3/16 inch screws
(P)
to attach the bracket to the back of the Dashboard
(D)
, sandwiching the Dashboard Reference
Card (E) between them and ensuring the cable is routed correctly (Figure 8D1). Use a 3mm Allen
wrench to remove the Omni module. Insert the Dashboard bracket (J) between the armrest and
the Omni module and attach using two M5 x 8mm hex head screws (O) (Figure 8D2).
Route the Dashboard cable toward the back of the
wheelchair, following existing cabling and using zip ties
(S) as needed (Figure 9A).
Note: For alternative drive wheelchairs, the Dashboard
(D)
includes an auxiliary jack. Any momentary switch
plugged into the jack can be used as the override button.
If not used, be sure to keep the dust plug in the jack.
Caution: All cables should be installed, bundled and
routed so as to avoid damage to the cables through
pinching, dragging, etc. and to avoid excess cable length
that could lead to entanglement or strangulation.
FOLLOW EXISTING CABLING
Tools Required
- Zip Ties (S)
STEP 9 - ROUTE THE DASHBOARD CABLE
Summary of Contents for SmartFrame ROVI X3
Page 1: ...INSTALLATION GUIDE ROVI X3...
Page 20: ...LUCI COM P002 054 v 2 0...
