Installing the WaveAC C ESS NET System 2-3
WaveACCESS NET CU132 Antennas
This section describes the WaveACCESS NET CU132
antenna and cable options, as follows:
✦
Antenna Types, below.
✦
Antenna Specifications, page 2-5.
✦
Cable Options, page 2-9.
✦
Installing the Antenna, page 2-11.
WARNING: The antenna connectors on the WaveACCESS
NET
CU132 front panel are non-standard. Care should be
taken that they are not damaged since they cannot be
replaced. In addition, antennas other than those supplied
with these products will not fit properly and might cause
harmful interference.
Note: All of the WaveACCESS NET outdoor antenna options
must be professionally installed. The cable kit provided with
all external antennas must be used for all outdoor antenna
installations. This kit includes a tension release cable from
the non-standard connector on the WaveACCESS NET unit to
a standard N-type connector. These antennas must be
professionally installed, complying with the certified
antenna and cable kits. Please carefully review and follow
the installation instructions included with each individual
antenna kit. If you have any questions, please contact your
nearest Technical Support center.
Refer to in
Chapter 3,
Technical Support
for information.
Antenna Types
The following section provides a description of the
antennas that are most commonly used with the
WaveACCESS NET products:
✦
Omnidirectional Antennas, page 2-4.
✦
Parabolic Dish Antenna, page 2-4.
✦
Sector Panel Antennas, page 2-4.
✦
Narrow Sector Panel Antennas, page 2-5.
