Installing the WaveAC C ESS LINK System 1-3
The WaveACCESS LINK Antennas
This section describes the WaveACCESS LINK antennas
and cable options, as follows:
✦
Antenna Types, below.
✦
Antenna Specifications, page 1-5.
✦
Cable Options, page 1-10.
WARNING: The antenna connectors on the WaveACCESS LINK
BR132 and the WaveACCESS LINK SM1024 front panel are non-
standard. Care should be taken that they are not damaged, since
they cannot be replaced. Additionally, antennas other than those
supplied with these products will not fit properly and might
cause harmful interference.
Note: All of the WaveACCESS LINK outdoor antenna options
must be professionally installed. The cable kit provided with all
external antennas must be used for all outdoor antenna
installations. This kit includes a tension release cable from the
non-standard connector on the WaveACCESS
LINK unit to a
standard N-type connector. These antennas must be
professionally installed, complying with the certified antenna
and cable kits. Please carefully review and follow the
installation instructions included with each individual antenna
kit. If you have any questions, please contact your nearest
Technical Support center. Refer to
Chapter 3, Technical Support
for information.
Antenna Types
The following section provides a description of the
antennas that are most commonly used with the
WaveACCESS LINK products, as follows:
✦
Parabolic Grid Antenna, page 1-4.
✦
Yagi Antenna, page 1-4.
✦
Omnidirectional Antennas, page 1-4.
✦
Planar Antenna, page 1-5.
✦
Parabolic Dish Antenna, page 1-5.
