Installing a Stinger FS or Stinger FS+
Setting up the unit
Stinger® FS/Stinger FS+ Getting Started Guide
2-3
Figure 2-1. Installing mounting brackets (older chassis shown)
2
Using a number 2 Phillips screwdriver, install 12 of the 1/4-inch number 8 flathead screws
that came with the brackets through the mounting bracket holes into the unit, as shown in
Figure 2-1 (only 8 of the 12 screws are displayed on each side).
!
Caution
Failure to use the proper screws may damage the unit.
3
Repeat step 1 and step 2 to install the second mounting bracket onto the other side of the
unit.
Installing the Stinger into a cabinet
The procedure for installing the unit into a cabinet requires that you supply a
minimum of four cross-head screws of the appropriate size to support the unit in the
cabinet.
!
Warning
The procedure for rack-mounting a unit with all components installed
requires more than one installer. Although new chassis are slightly lighter, a fully
populated Stinger FS or Stinger FS+ can weigh up to 160 pounds (72.6kg). Lucent
Technologies recommends using a mechanical lift to raise it into the cabinet.
To rack-mount a Stinger unit into an equipment cabinet:
1
Using a mechanical lift (or a minimum of three installers), raise the unit to the appropriate
installation height.
2
Align the screw holes on the mounting bracket with the screw holes on the equipment
cabinet.
3
Using a number 2 Phillips screwdriver, install cross-head screws of the appropriate size
through the mount bracket on the unit into the mounting bracket on the equipment cabinet.
16
16
15
15
14
14
13
13
12
12
11
11
10
10
ETHERNET
9
9
FDX
AC
T
TX
CD
MAJOR
MINOR
MASTER
TR
UNK
ST
ATUS
1
2
3
4
5
6
DIA
G POR
T
ETHERNET
8
8
FDX
AC
T
TX
CD
MAJOR
MINOR
MASTER
TR
UNK
ST
ATUS
1
2
3
4
5
6
DIA
G POR
T
7
7
6
6
5
5
4
4
3
3
2
2
