About This Guide
Stinger® FS/Stinger FS+ Getting Started Guide
xvii
Stinger documentation set
The Stinger documentation set consists of the following manuals, which can be found
at
http://www.lucentdocs.com/ins
:
■
Read me first:
–
Edge Access and Broadband Access Safety and Compliance Guide
. Contains
important safety instructions and country-specific information that you must
read before installing a Stinger unit.
–
TAOS Command-Line Interface Guide
. Introduces the TAOS command-line
environment and shows you how to use the command-line interface
effectively. This guide describes keyboard shortcuts and introduces
commands, security levels, profile structure, and parameter types.
■
Installation and basic configuration:
–
Getting Started Guide
for your unit. Shows how to install your Stinger chassis
and hardware. This guide also shows you how to use the command-line
interface to configure and verify IP access and basic access security on the
unit, and how to configure Stinger control module redundancy.
–
Module guides. For each Stinger line interface module (LIM), trunk module,
or other type of module, an individual guide describes the module's features
and provides instructions for configuring the module and verifying its status.
■
Configuration:
–
Stinger ATM Configuration Guide
. Describes how to use the command-line
interface to configure Asynchronous Transfer Mode (ATM) operations on a
Stinger unit. The guide explains how to configure permanent virtual circuits
(PVCs), and shows how to use standard ATM features such as quality of
service (QoS), connection admission control (CAC), and subtending.
–
Stinger IP Control Modules Configuration Guide
. For Stinger systems with an
IP2000 or IP2100 control module, this guide describes how to integrate the
system into the IP infrastructure. Topics include IP-routed switch-through
ATM PVCs and RFC 1483 PVCs that terminate on the IP2000, IEEE 802.1Q
VLAN, and forwarding multicast video transmissions on DSL interfaces.
–
Stinger Private Network-to-Network Interface (PNNI) Supplement
. Provides
quick-start instructions for configuring PNNI and soft PVCs (SPVCs), and
describes the related profiles and commands in the Stinger command-line
interface.
–
Stinger SNMP Management of the ATM Stack Supplement.
Describes SNMP
management of ATM ports, interfaces, and connections on a Stinger unit to
provide guidelines for configuring and managing ATM circuits through any
SNMP management utility.
–
Stinger T1000 Module Routing and Tunneling Supplement.
Describes how to
configure the Layer 3 routing and virtual private network (VPN) capabilities
supported by a Stinger T1000 module.
–
TAOS RADIUS Guide and Reference
. Describes how to set up a TAOS unit to use
the Remote Authentication Dial-In User Service (RADIUS) server and
contains a complete reference to RADIUS attributes.
■
Administration and troubleshooting:
