Lucent Technologies CAJUN P120, User Manual

Page: 104 / 130

Chapter 7 Cajun Campus CLI (Command Line Interface)
90 Cajun P120 User’s Guide
Set Interface Command
Use the
set interface command
to configure the in-band interfaces on the
agent.
The syntax for this command is:
set interface ib1 <vlan> <ip_addr[netmask]>
set interface sl0 <slip_addr> <dest_addr>
Note: The agent VLAN must be the same as the management station VLAN
Set Port Level Command
Use the
set port level
command to set the priority level of a port or range of
ports on the switching bus. Packets traveling through a port set at normal priority
are served only after packets traveling through a port set at high priority are served.
The Cajun P120 treats all the received BPDUs as high priority packets regardless of
the Port-Priority and to the Port Tagging Mode
. Unknown frames are always set to
low priority.
ib1
Ethernet interface name
sl0
SLIP interface name
ip_addr
IP address of Cajun P120
netmask
Subnet mask
vlan
Agent VLAN number
slip_addr
SLIP address
dest_addr
IP address of the 2 ends