Lucent Technologies CAJUN P120, User Manual

Page: 101 / 130

Chapter 7 Cajun Campus CLI (Command Line Interface)
Cajun P120 User’s Guide 87
Example:
To mirror all traffic from port 4 into port 5:
Console>(enable)
set port mirror source-port 4 mirror-port 5 sampling always
direction both
Mirroring both Rx and Tx packets from port 4 to port 5 is enabled.
Console>(enable)
Set Port Flow Control Command
Setting of flow control advertisement capabilities for Giga ports (only):
•
When giga auto-negotiation is enabled (via "set port negotiation … enable"
command, or via snmp), the "set port flowcontrol …" command decides on the
pause capabilities only.
• When giga auto-negotiation is disabled (via "set port negotiaton … disable
command, or via snmp), the "set port flowcontrol …" command decides on the
flow control mode itself.
The
show port flowcontrol
command displays "admin" and "oper" statuses
for both the receiving and the sending of FC frames (a total of 4 statuses). "Admin"
will refer to the pause capabilities, while "oper" will report the flow control mode
decided together with the other side. Here, when "admin / rcv" is on and "admin /
snd" is off, it refers to the pause capability state "symAndAsymRxFlowcontrol".
Set IP Route Command
Use the
set ip route
command to add IP addresses to the IP routing table. You
can configure one default gateway with up to ten (10) default gateways for P120
family.
The syntax for this command is:
set ip route <0.0.0.0> <gateway IP>
Example:
This example shows how to add a default route to the IP routing table:
Console>(enable) set ip route 0.0.0.0 192.122.173.42
Console>(enable)
gateway IP
IP address of the default gateway to access the network