Remote Port Security Device
User’s Guide
555-024-402
Issue 1
October 1996
Introduction
Page 1-5
Hardware Components
1
Hardware Components
To install a complete RPSD system, you need a Lock and a Key. A
communications system and modem are assumed to be at the customer site
already.
NOTE:
Although a printer is not essential to system operation, you should consider
dedicating a serial printer to the RPSD Lock. (The printer should be set to
9600 kbps, N, 8, 1.) The System Activity Log can store up to 1400
messages, but the only means of retaining a more permanent record of
system activity is either to install a dedicated printer for the RPSD Lock or to
save all messages from the Lock to disk.
The Lucent Technologies personnel who require access to the communications
system already have the Keys they need. Any additional RPSD Keys for customer
use must be ordered separately.
The hardware components (both supplied and otherwise) and their requirements
are described in the following sections.
RPSD Lock
When you order the RPSD Lock, you receive:
■
The Lock
■
Power supply
■
7-foot line cord with RJ11 modular connectors on each end
■
14-foot line cord with RJ11 modular connectors on each end
■
DB9 (male) to DB25 (female) cable
If any other cables or connectors are required, they must be ordered separately.
In addition, any peripheral devices, such as the administration terminal or printer,
are customer supplied. Install the RPSD Lock between the maintenance and
administration channel and the communications system modem.
