Spare part list
Floor watering system
Copyright © 2018 Lubing System - All rights reserved
17
3.6.12 Covers of the water trough
After the required drying time for all glue connections, install the covers on the water trough. The covers should be
placed flush on top of each other.
3.6.13 End cover/end cap for the water trough
Glue the end cap onto the end of the water trough. For adjustment of the end cover, first cut the end cover to the
desired length. The maximum length of the end cover is 2,500 mm. The rule of thumb for cutting the end cover is:
length = pad height minus 50 mm. Then cut the lower corner facing the wall to 30° from the end cover (see figure
below). Then attach the end covers with 6 screws each spread evenly across the length.
3.6.14 End cover of deflector
Now put on the end cover for the deflector and glue the transfer piece to
the spraying tube. After drying of the glue
points, the flat seal and closure cap can be attached.
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com