0940-1_M+B-PutentraenkeGB
LUBING Floor Watering System
- 12 -
3.6 Mixer
Overview on page 10, section 1
The LUBING Mixer must stand on a level and even surface.
The water supply connection is achieved via ¾“ Gardena Seals. When using a Main
Water Supply, a ¾“ hose can be laid from the Ball Valve in front of the Water Meter.
This requires a Hose Connector.
The standard version must be connected to mains voltage of 240 V 60 Hz using a
mains plug.
Please observe the information on mains voltage supplied on the delivery note.
3.7 Connection accessories
Overview on page 10, section 1
LUBING offers a variety of accessories for the water connection. We recommend
using the LUBING range of plastic pipes for pipework into the housing unit. Apart
from
∅
25 mm and ¾“ pipes, this range also includes Couplings, Bends ,T-pieces,
End Caps and Threaded Connection Pieces for both pipe diameters permitting all
kinds of pipework layouts. These components must be glued to ensure leak-proof
assembly.
Please refer to section 3.8 on Glued Connections.
The pipe system is secured to the wall or ceiling using Ceiling Clips, item no. 4349
for the 25 mm pipe and item no. 4329 for the ¾“ pipe. Mark the pipe layout and screw
down the Holders, item no. 4329 / 4349. Then press the pipes into the Holders.
Check the entire pipe system for leaks prior to commissioning.
LUBING recommends using the Water Connection Kit for connecting the drinking line
Pressure Regulator to the water supply. Depending on the kit, the following parts are
supplied:
Item no.
Components
4150
Clamp Ø ¾", Hose Connector, 3 m Tube ½“ and
Clips
4151
Clamp Ø ¾", Hose Connector, 4 m Tube ½“ and
Clips
4152
Clamp Ø ¾", Hose Connector, 5 m Tube ½“ and
Clips
4153
Clamp Ø ¾", Hose Connector, 3 m Tube ½“, Ball
Valve and Clips
4154
Clamp Ø ¾", Hose Connector, 4 m Tube ½“, Ball
Valve and Clips
4155
Clamp Ø ¾", Hose Connector, 5 m Tube ½“, Ball
Valve and Clips
