LTS LTH-D301GY-WIFI Quick Manual Download Page 3

Page: 3 / 9

pg. 3

Dipswitch & Wire Diagram

All Sub Module(s) back panel hides with the Dip Switch.

For the first time, it requires to be adjusted when you connect with the RS485 wire connection.

Remove the rubber cover on the sub-module rear panel to expose the DIP switch.
Set the sub-module address according to the DIP rules and install the rubber cover back. If you change any dipswitch, must power cycle to take effect.

(

Dipswitch 1,2,3,4 uses to coding the sub-module address

;

Dipswitch 5,6,7,8 is reserved

(All OFF as default);

Dipswitch 8 is for the

resistance(120Ω).

Valid sub module address range is 1 to 8, each sub-module address cannot be the same, otherwise, it will cause an error.)

Wire Connection:

Main Module to Sub Module

The RS485 wire connection from

M201-C

Main Module

RS485 output

to the 1

Sub module

RS485 input.

For more sub-modules, connect from the previous sub module
RS485 output to the next Sub-Module RS485 input and so on.
(You can find the RS485 cable from

the mount frame box

)

Outdoor Main Module M201-C wire diagram:

Note

: There are 2 door strike connections available in the main module.

However, you need to program the 2nd door strike with the Indoor Station LTH-D301GY-WIFI to push release it.
Meanwhile, the Mobile app LTS Connect only support to release the Door1 only. Please be aware of this.
Also, each Main module only supports up to 3 unlock passwords if use the M201-KP keypad to open.

Dipswitch

Sub 1

OFF

Reserve

Ω

Sub 2

OFF

Reserve

Ω

Sub 3

OFF

Reserve

Ω

Sub 4

OFF

Reserve

Ω

Sub 5

OFF

Reserve

Ω

Sub 6

OFF

Reserve

Ω

Sub 7

OFF

Reserve

Ω

Sub 8

OFF

Reserve

Ω

PoE Power Note:

The M201-C can be powered up with

standard 802.3af (15.4 watt) PoE input.  But if you have
touch screen module, it requires 802.3at PoE+ (30 watt)
up to 4 sub modules. Otherwise, 30watts can support
up to 8 sub modules without the touch screen module.

Recommend use 30W PoE power