SETTING THE EXPANDER PARAMETERS
-
CENTRAL AND EXPANSION NODES (CONTINUED)
FI750/RF/W2W
,
FI750/RF/CWE
and
FI750/RF/WE
require EN 54
-
4 compliant power supply units;
FI750/RF/W2W
can be power supplied
by the loop (as
long as the control panel is EN 54
-
4 compliant).
Power supply
’
s input supervision signals can be enabled and characterized in the
[PSU configuration]
window.
The
Save
option when preceded by an arrow, permits you to save the changes made:
[PSU configuration]
...
Mains
Mains fault.
Disable
: no fault check;
Open
: fault raised when input signal is in high impedance;
Low
: fault raised when input
signal is in a low state.
Batt fault
Battery fault.
Disable
: no fault check;
Open
: fault raised when input signal is in high impedance;
Low
: fault raised when input
signal is in a low state.
Charger fault
Battery charger fault.
Disable
: no fault check;
Open
: fault raised when input signal is in high impedance;
Low
: fault raised when input
signal is in a low state.
Batt O/C
Open battery circuit fault.
Disable
: no fault check;
Open
: fault raised when input signal is in high impedance;
Low
: fault raised when input
signal is in a low state.
[Edit system settings]
Save
Update completed
Press back to exit
The central node (Expander 1) doesn
’
t
need (remote) programming after the
Save option is selected.
On the contrary,
FI750/RF/WE
s in the system, if
their settings are modified, need expander
specific remote programming.
Remote expander programming is explained in
this manual.
Saving setting
’
s changes may require
some further programming or linking
actions, as requested by the device.
8
