LS tractor MT342, Operator'S Manual

Page: 80 / 264

3 - 4
2
Turn signal indicators (Left/Right)
3
Forward-reverse indicator (Not used)
4
High beam indicator
5 Parking brake indicator
6 Engine coolant temperature gauge

When turning on the high beam of the headlamps,
this indicator will be turned on simultaneously.
Do not turn on the high beam when a vehicle
comes in the opposite lane.
 This indicator will be turned on when applying
the parking brake. Do not drive the vehicle with
the parking brake applied.
 When turning on the turn signal lights with the
combination switch, the front/rear turn signal
lights and this indicator will blink simultaneously.
The key switch has to be in the “ON” or “Start”
positions. Before turning the vehicle while
driving on the road, turn on the turn signal lights.
 If the hazard warning lights are operated at the
same time when the turn signal is activated, the
hazard warning light for the opposite side of
turning direction will stop flashing and illuminate
continuously.
1
Tachometer
 The tachometer shows the engine revolutions
per minute (“30” means 3000rpm). The display
will return to zero when the engine is not running.
 This gauge indicates the engine coolant temperature during operation. It activates when the
operator turns the key switch to the ON position. The gauge will register cold with the key switch in
the OFF position.
 The closer the needle approaches “ H ” mark, the higher the temperature of engine coolant is. If the
needle moves to red portion of the gauge, this indicates an overheated condition. Stop the engine
immediately and check the problem.
 Coolant is very hot. When checking the coolant,
comply with the instructions of the chapter 5-13-(1),
“Replacement of Engine coolant” in this manual.
4
5
6
2 2 1 3